Table of Contents
Advertisement
Problem
Alarm does not operate.
Alarm will not Passively Arm.
Alarm will not enter Code
Learning Mode.
Alarm chirps 4 times 5
seconds after system is
Armed.
Parking lights do not flash.
Door locks do not lock/unlock
correctly, or action is reversed
Illuminated Entry does not
activate on upon disarm.
TROUBLESHOOTING
Probable Cause
Alarm in Valet Mode; Ignition
input has voltage on it; Missing
+12V or ground.
Unit is not programmed for
Passive Arming,wrong polarity
door input wire, Yellow
ignition input has 12V+ on it.
Ignition was not left in the on
position after turning it on &
off three times; Sequence not
performed rapidly enough (5
sec.);Valet/Override Switch is
defective or not plugged in.
Factory Dome light Delay is
longer than 5 seconds; Door
open or defective pin switch;
Shock sensor is not properly
adjusted or defective.
Wrong wire connected to the
WHITE wire, or wrong
polarity.
Defective GREEN or BLUE wire
from door lock connector plug,
GREEN and BLUE wires reversed,
or wrong door lock wiring
diagram used.
Wrong polarity selected.
10
Suggested Correction
Take alarm out of Valet mode;
Turn key off and verify yellow
wire is connected to correct
ignition wire; Check +12V and
ground connections.
Program step #2 for Passive
Arming; Correct door switch
polarity; Change ignition input
wire; Make sure alarm is not in
Valet.
Leave ignition in on position;
Repeat procedure quicker;
Replace valet switch.
If dome light delay is longer
than 5 seconds program step 5
to OFF; Replace defective pin
switch;Adjust or replace shock
sensor.
Connect WHITE wire to the
proper vehicle wire, Change
jumper polarity of Parking Light
relay (see Jumper Settings).
Check GREEN and BLUE wires on
door lock connector plug, Check
vehicle's door lock system for
method of operation. Reverse
wiring to door relays.
Change jumper polarity of the
Dome Light relay.
Advertisement
Table of Contents
