Advertisement
the 2nd channel is used for opening the
trunk or hatch, the alarm (if armed) will
automatically disarm.
To program these specific features
follow the procedure below:
1.Turn ignition key to the ON position
2. Press the valet switch 5 times (siren will
give long chirp).
3.Then select the program that you wish
to change and press the valet switch the
same number of times.The siren will
chirp each time you press the switch.
Summary of Inputs and outputs:
Inputs:
1 Sensor port-4 wire (w/warn away)
1 Sensor port -3 wire
Negative door trigger
1 Negative hood/trunk trigger
1 Positive door trigger
*Module with door lock relays on board
Dip Switch Programmable Features:
Switch #1= Lock/Unlock Pulse Time:
Switch #2= Ignition Triggered Door Locks: ON= Feature On
Switch #3= Passive Door Locks:
Switch #4= Passive or Active Arming:
4. Press button one or two on the trans-
mitter to change to the desired program
to the feature.
Example: Programming the 3rd channel to
horn output.
1. Ignition Key On,
2. Press Valet switch 5 times
3. Siren will give long chirp,
4. Next, press Valet switch 3 times, siren will
chirp after each time you press the switch
5. Press button #2 on transmitter
6.Turn ignition key off.The red/white wire on
the main harness now is programmed to be
Outputs
Siren output: 3 amp Max - positive
Flashing lights: relayed - 15 amp Max
Starter Interrupt: relayed:40 amp (N.C.)
Dome Light: relayed- 15 amp Max
Door lock/unlock : 500 ma -negative
Door lock/unlock: relayed* 15 amp max
2 nd Channel: 500 ma- negative
3rd Channel: 500 ma - negative
Armed Output: 250 ma - negative
ON= .75 seconds
ON= Feature On
ON= Passive Arm OFF= Active Arm
3
OFF= 3 seconds
OFF= Feature OFF
OFF= Feature OFF
Advertisement
