Download Print this page

Belson ESI-12F Use And Care Book page 2

Professional flat stove iron

Advertisement

2001_2_15_87_BP
3/5/01
4:04 PM
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATION
Heat-resistant
Closed end for
rotating handles
consistent, even
heat distribution
High-quality steel
barrel holds heat longer
WARNING: Due to the extreme heat capabilities of this iron, extra
care should be taken when using.
IMPORTANT:
This iron has been coated with a special oil to temper the barrel
and protect it during shipping. When heating for the first time,
preheat iron 4 to 5 minutes. You will notice some smoke and a slight
odor. This is normal and will quickly disappear.
Page 2
TO USE:
1. Insert iron into heater stove and heat for 1 to 3 minutes,
depending upon the strength of the curl you desire and the type
and texture of hair it is used on.
CAUTION: After initial heating to remove oil, do not allow iron to
heat for more that 3 minutes. The extreme heat may damage hair.
If iron is heated for more than 3 minutes, do not use; remove it and
let it cool. (Time may vary due to barrel size and number of irons
heated at one time. Test iron on a small section of hair before
using.)
2. For styling, section hair into strands of not more than 1 inch deep
and 2 inches wide.
3. Keep the hair strand smooth by brushing or combing through the
section while holding the ends taut with the other hand.
4. Taking one section at a time, place the ends of hair under the
barrel with the clamp open. Then close the clamp making sure
that the ends extend just a tiny bit beyond the clamp.
5. Keep the section of hair taut as you wind it around the hot barrel
by turning the handle. Wind the curl toward scalp as far as you
wish to go without touching scalp with the hot barrel.
6. When you are ready to release curl, unwind about half a turn
(for longer hair, unwind a bit more) and open the clamp.
7. Now, gently withdraw the barrel from the center of curl.
8. Allow curl to cool, and try not to disturb curls as you proceed
in the same manner around whole head.
STYLING TIP: For bouncy, flip-up curls, the clamp should be under
and the barrel over the section of hair at the start of curl. For curl-
under, page-boy styles, the clamp should be over and the barrel
under the hair section at the start of curl.

Advertisement

loading

This manual is also suitable for:

Esi-8f