Chapter 3: Advanced Configuration; Setup > Basic Setup; How To Access Web-Based Utility - Cisco WRT54GS - Wireless-G Broadband Router User Manual

Chapter3
Chapter 3:
Advanced Confguraton
After setting up the Router with EasyLink Advisor or the
Setup Wizard (located on the CD-ROM), the Router will be
ready for use. However, if you'd like to change its advanced
settings, use the Router's web-based utility. This chapter
describes each web page of the utility and each page's key
functions. You can access the utility via a web browser on
a computer connected to the Router.
The web-based utility has these main tabs: Setup,
Wireless, Security, Access Restrictions, Applications &
Gaming, Administration, and Status. Additional tabs will
be available after you click one of the main tabs.
NOTE:
When first installing the Router, you
should use the Setup Wizard on the Setup
CD-ROM. If you want to configure advanced
settings, use this chapter to learn about the
web-based utility.
How to Access the Web-Based Utility
To access the web-based utility, launch the web browser on
your computer, and enter the Router's default IP address,
92.68.., in the Address field. Then, press Enter.
A password request screen will appear. (Non-Windows XP
users will see a similar screen.) Leave the User name field
blank. The first time you open the Web-based utility, use
the default password admn. (You can set a new password
from the Administration tab's Management screen.) Click
the OK button to continue.
Password Screen
Setup > Basic Setup
The first screen that appears is the Setup > Basic Setup
screen. This allows you to change the Router's general
settings.
Wreless-G Broadband Router wth SpeedBooster
Advanced Configuration
Setup > Basic Setup
Internet Setup
The Internet Setup section configures the Router to your
Internet connection. Most of this information can be
obtained through your ISP.
Internet Connection Type
Select the type of Internet connection your ISP provides
from the drop-down menu. The available types are:
Automatic Configuration - DHCP
•
Static IP
•
PPPoE
•
PPTP
•
Telstra Cable
•
L2TP
•
Automatic Configuration - DHCP
By default, the Router's Internet Connection Type is set
to Automatc Confguraton - DHCP, which should be
kept only if your ISP supports DHCP or you are connecting
through a dynamic IP address. (This option usually applies
to cable connections.)
Internet Connection Type > Automatic Configuration - DHCP
3