4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screws securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
Use a point size 0 Phillips screwdriver.
6. Slide your fingernail or a thin object under the cover and lift it off.
1. Memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
holding it down until the latches on either side snap into place.
1. Notch
2. Slot B
User's Manual
section in Chapter 6,
2. Screws
Removing the memory module cover
3. Slot A
Seating the memory module
Hardware, Utilities and Options
Power and Power-Up
1
2
1
2
3
3-18