Front Panel - Krell Industries Evolution 707 Quick Setup Manual

Figure 1 The Evolution 707 Front Panel

FRONT PANEL

AND REMOTE
FUNCTIONS
Access functions via the
buttons or knob on the front
panel, or from the corres-
ponding key on the remote.
BASIC OPERATION
1 Power Button/Key
Turns the Evolution 707 from
stand-by to operational mode,
and turns the 12 VDC output
(12 V trigger) on and off.
2 Power/Stand-by LED
Stand-by Mode. When the
AC power cord is plugged
into the wall, and the back
panel switch is in the on
position, the LED illuminates
in red: the Evolution 707 is in
stand-by mode.
2
Operational Mode. When the
power/stand-by button is
pressed while the Evolution
707 is in stand-by, the LED
illuminates in blue: the
Evolution 707 is in the opera-
tional mode.
3 Infrared Sensor
Receives commands from
the Evolution 707 remote
control.
4 Infrared Emitter
Sends the Evolution 707
remote operation code to a
learning remote.
INPUT DEVICE SELECTION
The Evolution 707 is equipped
with ten input device selection
buttons on the front panel and
corresponding keys on the re-
mote control. Any video or audio
function can be assigned to any
one of these buttons. When prop-
erly configured, the Evolution 707
automatically engages the correct
video and audio inputs when you
press the device selection button.
5 DVD Button/Key
6 DVDR Button/Key
7 SAT Button/Key
8 VCR Button/Key
9 TV Button/Key
10 CD Button/Key
11 Tuner Button/Key
12 DVR Button/Key
13 Game Button/Key
14 Tape/VCR2 Button/Key
Playback pre-recorded tapes;
compare the output signal of
an analog tape recorder to an
audio source.
ALTERNATIVE INPUT
SELECTION
15 Microphone Connection
For use with a Krell-supplied
microphone, to calibrate
equipment.
ZONE INDICATOR
16 Zone 2 Button/Key
The LED illuminates green on
the left if the main zone is
active, and illuminates red on
the right if Zone 2 is active.
On the front panel, press the
zone 2 button to activate and
change zones. On the remote,
press the main key to activate
the main zone . Press the Z2
key to activate zone 2.
PROCESSING MODE
17 Preamp Button/Key
Sends the signal from an ana-
log input directly to the vol-
ume control, with no digital
processing, using the pream-
plifier analog stage. Used for
components with a high quali-
ty signal, such as the Krell
Evolution 505 CD Player to
avoid possible digital signal
degradation.
Note: This feature is available
with a signal from an analog
input. If you attempt to use it
with a signal from a digital
input, the OSD reads
NOT
ALLOWED
18 Stereo Button/Key
Selects stereo decoding. The
red LED illuminates when this
function is engaged.
Krell Evolution 707