Kogan KACOFXXAUTB User Manual page 15

ME-711
Fully-automatic Coffee Machine
Turn off the power, pull out the plug, then open
the brewing door [13].
Lift the handle on the brewing unit, and
press the flake which there is a written
word "press" on top of it. Take out the
brewing unit. Clean the main equipment
with hot water without impregnant. Be
sure there is no coffee dreg on the two
filters, then dry it.
Take out dreg plate and dreg drawer ,clean
them with unrough impregnant
Turn off the power and
open brewing door
Press here
Take out of brewing unit
correctly and clean it
Take off the dreg drawer
and the dreg plate
Clean the area around brewing unit
competely. And then, install dreg drawer
again.
Clean the area
around brewing unit
Note: When put back the brewing unit,never push the flake where
there is a word"press",or it will cause damage to the machine.
Warning : If the brewing unit is not in the correct place,display show
BREWING UNIT MISSING,and machine can not work properly.
Usually, the bean tank is not required to be clean. Clean it with cotton if needed.
Note:Never add water into bean tank, otherwise it will cause damage to machine.
Clean the milk-frothing device
Take off the metal tube, Spout can be taken off
with the spanner on the spoon.Clean the metal
tube and nozzle with water. If the nozzle was
blocked, clean it with pin, wash it with water.
Re-assembly after cleaning.
Warning :Make sure the machine is power off and the steam/hot water pipe is
cooling down completely
USER MANUAL
21/22
Take out brewing original unit with handle.
Slide into the initial position. Be sure the
brewing unit is well positioned after hearing
"clip", then install the dreg drawer. Close the
brewing door finally.
D on 't press h ere
Put back brewing unit
Nozzle
Milk-Frothing
Metal tube
Clean metal tube and nozzle
to keep the spout expedite