Initial Operation; Online Registration; Control Elements And Connectors; Mono Channels - Behringer EURORACK UB1202FX User Manual

6
EURORACK UB1202FX/UB1002FX User Manual
◊
Please always use the original packaging to avoid damage due to
storage or shipping.
◊
Never let unsupervised children play with the EURORACK or with
its packaging.
◊
Please dispose of all packaging materials in an
environmentally-friendly fashion.

1.3.2 Initial operation

Be sure that there is enough space around the unit for cooling purposes and to
avoid overheating please do not place your mixing console on high-temperature
equipment such as radiators or power amps.
◊
Never connect the EURORACK to the power supply unit when the latter
is connected to the mains! First connect the power supply unit to the
console, then connect the power supply unit to the mains.
◊
Please make sure that all units have a proper ground connection.
For your own safety, never remove or disable the ground
conductor from the unit or on the AC power cord. The unit should
always be connected to a mains socket outlet with a protective
earthing connection.
◊
When installing the product, ensure the appliance coupler or power
cord is easily accessible for disconnecting the unit from mains.

1.3.3 Online registration

Please register your new BEHRINGER equipment right after your purchase
by visiting http://behringer.com and read the terms and conditions of our
warranty carefully.
Should your BEHRINGER product malfunction, it is our intention to have it
repaired as quickly as possible. To arrange for warranty service, please contact
the BEHRINGER retailer from whom the equipment was purchased. Should your
BEHRINGER dealer not be located in your vicinity, you may directly contact
one of our subsidiaries. Corresponding contact information is included in the
original equipment packaging (Global Contact Information/European Contact
Information). Should your country not be listed, please contact the distributor
nearest you. A list of distributors can be found in the support area of our website
(http://behringer.com).
Registering your purchase and equipment with us helps us process your repair
claims more quickly and efficiently.
Thank you for your cooperation!

2. Control Elements and Connectors

this chapter describes the various control elements of your mixing console.
All controls, switches and connectors will be discussed in detail.

2.1 Mono channels

1
MIC
LINE
IN
BAL
OR
UNBAL
GAIN
+10 – 10 + 40 + 60
EQ
0
HIGH
12 kHz
–15 +15
0
MID
2.5 kHz
–15 +15
0
LOW
80 Hz
–15 +15
LOW CUT
0
+15
PAN
CLIP
L R
0
LEVEL
+15
1
Fig. 2.1: Connectors and controls on the mono channels
MIC
Each mono input channel offers a balanced microphone input via the XLR
connector and also features a switchable +48 V phantom power supply for
condenser microphones.
◊
Please mute your playback system before you activate the phantom
power supply to prevent switch-on thumps being directed to your
loudspeakers. Please also note the instructions in chapter 2.4
"Main section".
LINE IN
Each mono input also features a balanced line input on a 1/4" connector.
Unbalanced devices (mono connectors) can also be connected to these inputs.
◊
Please remember that you can only use either the microphone
or the line input of a channel at any one time. You can never use
both simultaneously!