AEG 79902G Operating Instructions Manual page 33

Setting the hob for the new
gas type
1. If necessary, activate the hob by touching
the main ON/OFF Control
seconds.
2. Touch the Timer Control
select the auxiliary burner (front left burner)
on the burner selection display .
3. Touch the Increasing Control
the finger on it until the value 99 appears
on the time display. Then, touch the
Decrasing Control
on it until the value 80 is displayed.
4. Then, touch the Increasing Control
83 is displayed. At this point, the hob is set
to the "Gas Change" mode and the current
gas setting appears on the display:
n0
- stands for gas G20 (20 mbar)
n1
- for gas G30 (28-30/37 mbar).
IMPORTANT: setting
the hob to function.
for about 3
repeatedly to
and hold
and hold the finger
until
n2
does not allow
33