Adjusting The Direction Of Air Circulation - Fujitsu ASTA18JCC Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

● Adjust the up, down, left, and right AIR directions with the AIR DIRECTION buttons on the Remote Control Unit.
● Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the airflow-direction louvers have
stopped moving.
Vertical Air Direction Adjustment
Press the SET button (Vertical) (Fig. 6 R).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air flow Direction Setting:
1,2,3 :
During Cooling/Dry modes
1,2,3,4,5,6 :
During Fan mode
The Remote Control Unit's display does
not change.
● Use the air direction adjustments within the ranges shown above.
● The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry/Fan mode : Horizontal flow 1
● During AUTO mode operation, for the first minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this pe-
riod.
● Direction 1 2
Only the direction of the Air Flow Direction Louver changes; the direction of the
Power Diffuser does not change.
Horizontal Air Direction Adjustment
Press the SET button (Horizontal)(Fig. 6 S).
● Each time the button is pressed, the air direction range will change as follows:
1
The remote control unit's
display does not change.
07H093_9315345141-01_En_body
2 3 4 5
1
2
3
4
5
6
2 3 4 5
1
2
3
4
10
R DANGER!
● Never place fingers or foreign objects in-
6
● Always use the Remote Control Unit's
● During Cooling and Dry modes, do not
● When used in a room with infants, chil-
5
2007.08.21, 16:05
side the outlet ports, since the internal fan
operates at high speed and could cause
personal injury.
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper op-
eration; in this case, stop operation and
restart. The louvers should begin to
operate properly again.
move the vertical air direction louvers
outside their proper operating range
for the mode (1 - 3) and into the fan
region (4 - 6); using the louvers in
the fan region will cause moisture to
condense near the air outlet, and wa-
ter may drop onto the floor. During the
Cooling/Dry modes, if the louvers are
operated outside the range 1 - 3 for
more than 20 minutes, they will be
automatically returned to the 3 range.
dren, elderly or sick persons, the air
direction and room temperature
should be considered carefully when
making settings.
10