Fujitsu ASTG18LF Operating Manual page 5

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●
When the MANUAL AUTO button is pressed
in for more than 10 seconds, the forced
cooling operation will start.
●
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's use.
●
When the forced cooling operation starts by
any chance, press the START/STOP button
to stop the operation.
●
Please press the button at FILTER INDICA-
TOR RESET.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (green)
6 TIMER Indicator Lamp (orange)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a fault
has occurred with the timer setting (See
Page 18 Auto Restart).
7 ECONOMY Indicator Lamp (green)
●
ECONOMY indicator lamp lights when
ECONOMY OPERATION and 10 °C HEAT
OPERATION are operating.
8 INTAKE GRILLE (Fig.4)
9 Front Panel
0 Air Filter
A Airfl ow Direction Louver
B Power Diffuser
C Right-Left Louver
(behind Airfl ow Direction Louver)
D Drain Hose
E Air Cleaning Filter
9315345387_OM_EN.indb 4 9315345387_OM_EN.indb 4
Fig. 5 Remote Controller
F Signal Transmitter
G MODE button
H 10 °C HEAT button
I ECONOMY button
J SLEEP button
K TIMER MODE button
L FAN button
M START/STOP button
N SET button (Vertical)
O SET button (Horizontal)
P SWING button
Q SET TEMP. button (
R TIMER SET ( / ) button
S CLOCK ADJUST button
T TEST RUN button
● This button is used when installing the air
conditioner, and should not be used under
normal conditions, as it will cause the indoor
unit's thermostat function to operate incor-
rectly.
● If this button is pressed during normal op-
eration, the indoor unit will switch to test op-
eration mode, and the Indoor Unit's OPER-
ATION Indicator Lamp and TIMER Indicator
Lamp will begin to fl ash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
U RESET button
V Remote Controller Display (Fig.6)
W Temperature SET Display
X Operation Mode Display
Y SLEEP TIMER Display
Z Transmit Indicator
[ Fan Speed Display
\ SWING Display
] T imer Mode Display
^ Clock Display
/ )
En-4
12/2/2010 8:44:35 AM 12/2/2010 8:44:35 AM