Chain/Cover Needles; T Left Needle - C-1; S Center Needle - C-2; Right Needle - C-3 - Baby Lock Model BLCS Instruction Manual

Chain / Cover Needles
Left Needle C-1
1. Raise presser foot and place the thread on the far left spool pin. Slip the thread into the tele-
scopic antenna thread guide directly above the thread spool. See drawings below for refer-
ence.
2. Bring thread down from the telescopic antenna, snap thread into the red thread guide on the
top of the machine, and then down into the red hole above the tension dial.
3. Bring the thread down the right side of the red tension dial, under the dial and back up the
left side, making sure the thread is in the tension disk.
4. Bring the thread through thread guide at top of machine and down to the pre-tension thread
guide above the needle.
5. Pass the thread from the left side behind the pre-tension thread guide plate on needle clamp
and into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the left
"C-1" needle position.
Center Needle C-2
1. Raise presser foot and place the thread on the second from the left spool pin. Slip the thread
into the telescopic antenna thread guide directly above the thread spool. See drawings below
for reference.
2. Bring thread down from the telescopic antenna, snap thread into the yellow thread guide on
the top of the machine, and then down into the yellow hole above the tension dial.
3. Bring the thread down the right side of the yellow tension dial, under the dial and the thread
guide below the dial.
4. Bring the thread through thread guide at top of machine and down to the pre-tension thread
guide above the needle.
5. Pass the thread from the right side behind the pre-tension thread guide plate on needle clamp
and into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the cen-
ter "C-2" needle position.
Right Needle C-3
1. Raise presser foot and place the thread on the back right spool pin. Slip the thread into the
telescopic antenna thread guide directly above the thread spool. See drawings below for refer-
ence.
2. Bring thread down from the telescopic antenna, snap thread into the green thread guide on
the top of the machine, and then down into the green hole above the tension dial.
3. Bring the thread down the right side of the green tension dial, under the green dial and under
the thread guide located below the yellow tension dial.
4. Bring the thread through thread guide at top of machine and down to the pre-tension thread
guide above the needle.
5. Pass the thread from the right side behind the pre-tension thread guide plate on needle clamp
and into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the right
"C-3" needle position.
NOTE :
After threading the needles, the thread is then place to the left and top of the presser foot.
T
H
R
E
A
D
I
N
G
15