Related Manuals for Behringer C-3
Summary of Contents for Behringer C-3
- Page 1 User Manual STUDIO CONDENSER MICROPHONE Dual-Diaphragm Studio Condenser Microphone...
-
Page 2: Limited Warranty
STUDIO CONDENSER MICROPHONE C-3 User Manual LIMITED WARRANTY Important Safety Instructions For the applicable warranty terms and conditions and additional information regarding MUSIC Group’ s Limited Warranty, please see complete details online at www.music-group.com/warranty. LEGAL DISCLAIMER Terminals marked with this symbol... -
Page 3: Power Supply
LED on the microphone lights up. BEHRINGER assumes no liability for any damage caused by a defective phantom power supply. Always mute the sound reinforcement system before you switch on the phantom power supply. -
Page 4: Microphone Installation
STUDIO CONDENSER MICROPHONE C-3 User Manual 3. Low Cut-Filter and Signal Level Attenuation The low cut filter is activated via the left switch located at the front of your C-3 (switch position: left, ). Disruptive, low-frequency sounds such as subsonic noise, snapping and wind sounds can be filtered out. -
Page 5: Audio Connection
STUDIO CONDENSER MICROPHONE C-3 User Manual If necessary, you can bend the microphone out of its vertical position by using the hinge on the microphone stand. ◊ Please make sure to handle the microphone shaft with attention and care to avoid damaging the screw thread. In no situation should you ever apply excessive force. - Page 6 STUDIO CONDENSER MICROPHONE C-3 User Manual 0˚ 5 dB 45˚ 45˚ 10 dB 15 dB 20 dB 25 dB 90˚ 90˚ 135˚ 135˚ 180˚ Super Cardioid Figure 8 Omni Polar pattern 500 1000 2000 5000 10000 20000 Hz Cardioid Low Cut...
-
Page 7: Specifications
0.42 kg BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. Specifications and appearance may differ from those listed or illustrated. - Page 8 We Hear You...
Need help?
Do you have a question about the C-3 and is the answer not in the manual?
Questions and answers