Gigabyte GA-EP43T-UD3L User Manual page 46

• Auto
• None
• Manual
Access Mode
IDE Channel 2, 3 Master, 4 Master/Slave
IDE Auto-Detection
Press <Enter> to autodetect the parameters of the IDE/SATA device on this channel.
Extended IDE Drive
Configure your IDE/SATA devices by using one of the two methods below:
• Auto
• None
Access Mode
The following fields display your hard drive specifications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity
Cylinder
Head
Precomp
Landing Zone Landing zone.
Sector
Drive A
Allows you to select the type of floppy disk drive installed in your system. If you do not install a floppy
disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5",
2.88M/3.5".
Floppy 3 Mode Support
Allows you to specify whether the installed floppy disk drive is 3-mode floppy disk drive, a Japanese
standard floppy disk drive. Options are: Disabled (default), Drive A.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
All Errors
No Errors
All, But Keyboard The system boot will not stop for a keyboard error but stop for all other errors. (Default)
All, But Diskette The system boot will not stop for a floppy disk drive error but stop for all other errors.
All, But Disk/KeyThe system boot will not stop for a keyboard or a floppy disk drive error but it will
Memory
These fields are read-only and are determined by the BIOS POST.
Base Memory Also called conventional memory. Typically, 640 KB will be reserved for the
Extended Memory The amount of extended memory.
Total Memory
GA-EP43T-UD3L Motherboard
Lets BIOS automatically detect IDE/SATA devices during the POST. (Default)
If no IDE/SATA devices are used, set this item to None so the system will skip the
detection of the device during the POST for faster system startup.
Allows you to manually enter the specifications of the hard drive when the hard drive
access mode is set to CHS.
Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large.
Lets BIOS automatically detect IDE/SATA devices during the POST. (Default)
If no IDE/SATA devices are used, set this item to None so the system will skip the
detection of the device during the POST for faster system startup.
Sets the hard drive access mode. Options are: Auto (default), Large.
Approximate capacity of the currently installed hard drive.
Number of cylinders.
Number of heads.
Write precompensation cylinder.
Number of sectors.
Whenever the BIOS detects a non-fatal error the system boot will stop.
The system boot will not stop for any error.
stop for all other errors.
MS-DOS operating system.
The total amount of memory installed on the system.
- 46 -