Behringer EUROLIVE B312A User Manual page 4

Processor-controlled 400-watt 2-way pa speaker system with 12"/15" woofer and 1.75" titanium compression driver
Hide thumbs Also See for EUROLIVE B312A:
Table of Contents

Advertisement

4
The
LINK OUTPUT is directly connected to the inputs
[ 3 ]
of the B312A/B315A and carries the input signal with no
processing applied. In this way, you can route the signal
to the input of another device (for example, a second
B312A/B315A)
To set the volume of the LINE or MIC signal, use the
[ 4 ]
LEVEL control. The left half of the control range is for
attenuating the LINE signal. The right half is for raising
the level of the MIC signal.
The
CLIP LED lights up when signal distortion occurs.
[ 5 ]
Reduce the volume with the LEVEL control until the CLIP
LED does not light up any more, or occasionally lights up at
signal peaks.
We would like to draw your attention to the fact that
extremely loud sound levels may damage your hearing as
well as your headphones/loudspeakers. Turn the LEVEL
control fully to the left before you switch on the unit.
Be careful to select a suitable volume at all times.
The
HIGH control adjusts the high-frequency range.
[ 6 ]
Use the
LOW control to raise the level of the low-frequency
[ 7 ]
range.
The
PWR LED lights up when the loudspeaker is put into
[ 8 ]
operation.
EUROLIVE B312A/B315A User Manual
Fig.2.2: Control elements and connections B312A and B315A)
You can replace fuses at the
[ 9 ]
B312A/B315A. Always replace fuses with the same type.
Please follow the instructions given in the chapter
"Specifications."
The mains connection is established using a cable with
[ 1 0]
an IEC mains connector. This cable is delivered with the
B312A/B315A. To avoid ground-loop hum, loudspeakers
and mixing consoles should be connected to the same power
circuit.
Press
POWER to turn on your B312A/B315A.
[ 1 1]
The POWER switch does not fully disconnect the unit from
the mains. To disconnect the unit from the mains, pull out
the main cable plug or appliance coupler. When installing
the product, ensure the plug or appliance coupler is readily
operable. Unplug the power cord completely when the unit
is not used for prolonged periods of time.
Serial number
[ 1 2]
FUSE SWITCH of the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eurolive b315a

Table of Contents