Viewing The Display; Selecting The Video Signal-Source; Storing Channels Automatically - Samsung LN19A330 - 19" LCD TV User Manual

Viewing the Display

The display identifies the current channel and the status of certain audio-video settings.
1. Press the INFO button on the remote control.
The TV will display the channel, the type of sound,
and the status of certain picture and sound settings.
Press the INFO button once more or wait approximately 10 seconds and it
disappears automatically.

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to
the TV (i.e. an antenna or a cable system).
1. P ress the MENU button to display the menu.
Press the ▲ or ▼ button to select "Channel", then press the ENTER
2. Press the ENTER
button to select "Air/Cable".
3. Press t he ▲ or ▼ button to select the video signal source, then press the
ENTER
button.
4. Press the EXIT button to exit.

Storing Channels Automatically

The TV automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
1. T o select the signal source, follow the "Selecting the Video Signal-source"
instructions numbers 1 to 3.
2. Press the ▲ or ▼ button to select "Auto Program", then press the ENTER
3. P ress the ENTER
button to select "Start".
The channel search will start and end automatically.
Press the ENTER
and return to the "Channel" menu.
4. After all the available channels are stored, the "Channel" menu reappears.
5. Press the EXIT button to exit.
Press the AUTO PROG. button on the remote control.
button at any time to interrupt the memorization process
button.
button.
English - 
Air 
Mono
Picture : Dynamic
Sound : Custom
MTS : Stereo
0 :  pm
Air/Cable : Air
Auto Program
Add/Delete
Fine Tune
Move Enter
Air
Cable
Move Enter
Air/Cable : Air
Auto Program
Add/Delete
Fine Tune
Move Enter
Channel




Return
Air/Cable
Return
Channel




Return