Advertisement
* The front fender is secured to the frame by the 5 screws provided. Examine the
bottom of the front fender. You will notice plastic tubes protruding from the
bottom (Fig 7A). These tubes must be lined up with the holes in the front frame
assembly (Fig 7B). Line up the front fender and press onto the front frame
* The front fender is secured to the frame by the 5 screws provided. Examine the
assembly (Fig. 7C). Insert the 5 screws through the underside of the front frame
• The footrest is secured to the frame by the 4 screws provided. Line up the holes on
bottom of the front fender. You will notice plastic tubes protruding from the
assembly into the front fender's plastic tubes (Fig. D). Tighten the screws only
the plastic footrest with the holes on the frame to secure. See figure 8a. Line up the
bottom (Fig 7A). These tubes must be lined up with the holes in the front frame
until snug. Do Not over-tighten.
front footrest and press onto the front frame assembly. Insert the 4 screws through
assembly (Fig 7B). Line up the front fender and press onto the front frame
the underside of the front frame assembly into the front footrest's plastic tubes.
assembly (Fig. 7C). Insert the 5 screws through the underside of the front frame
Tighten the screws only until snug. See figure 8b.
* Lean the stroller forward to rest on the front wheel. To attach the rear wheels,
assembly into the front fender's plastic tubes (Fig. D). Tighten the screws only
Do Not over-tighten.
push each wheel into the plastic corner fitting as shown in figure 8. Lift upward
until snug. Do Not over-tighten.
on the plastic lever on the inside of the corner fitting as you push the axle into
corner fitting. When the wheel will not go on any farther, release the lever. Check
* Lean the stroller forward to rest on the front wheel. To attach the rear wheels,
that the wheel has locked into the corner fitting by pulling on the wheel. If not
push each wheel into the plastic corner fitting as shown in figure 8. Lift upward
locked, lift upward on the lever, push the wheel on farther and release lever.
on the plastic lever on the inside of the corner fitting as you push the axle into
corner fitting. When the wheel will not go on any farther, release the lever. Check
* Ensure that the wheels are firmly locked into place. Do Not use the stroller if the
that the wheel has locked into the corner fitting by pulling on the wheel. If not
wheels are not locked into place, but rather contact our customer service
locked, lift upward on the lever, push the wheel on farther and release lever.
department immediately at (800) 328-7363, between the hours of 8:00am and
4:30pm PCT, for assistance.
* Ensure that the wheels are firmly locked into place. Do Not use the stroller if the
wheels are not locked into place, but rather contact our customer service
* Insert the tray clips into the female fittings on the stroller's fold joints: check that
department immediately at (800) 328-7363, between the hours of 8:00am and
the button on the bottom locks into place. See Fig. 8A
4:30pm PCT, for assistance.
* To attach the front child tray, push the angled tray onto the post at the end of the
* Insert the tray clips into the female fittings on the stroller's fold joints: check that
tray clip, while pressing downward on the snap button, until locked into place.
the button on the bottom locks into place. See Fig. 8A
Please see figure 8B. Rotate the tray downward until latched onto the left tray
10
clip. Please check the the snap button comes through and securely latches the tray
* To attach the front child tray, push the angled tray onto the post at the end of the
in place. Please see figure 9.
tray clip, while pressing downward on the snap button, until locked into place.
Please see figure 8B. Rotate the tray downward until latched onto the left tray
* To open the front child tray, press inward on left side tray release button and
clip. Please check the the snap button comes through and securely latches the tray
rotate upward on the tray. Please see figure 10. Please note that you may remove
in place. Please see figure 9.
the tray completely by depressing the button under the arm as shown in figure
the tray completely by depressing the buttons on each side as shown in figure 11.
11. while pulling forward on the tray.
while pulling foward on the tray.
* To open the front child tray, press inward on left side tray release button and
rotate upward on the tray. Please see figure 10. Please note that you may remove
the tray completely by depressing the buttons on each side as shown in figure 11.
while pulling foward on the tray.
Fig 10.
10A.
10B.
Please note that you may remove
Fig 10A.
9
Fig 10B.
Fig 8a.
Fig 8b.
Fig 9.
Fig 11.
3
Advertisement
