Indicator Lamps; Remote Control - BMW Z4 3.0i Owner's Manual

for more than 2 seconds after the LED has gone
out.<
When the convertible top has been stored
in the convertible top compartment for an
extended period of time, e.g. in the winter
months because the hardtop was being used,
you may have to support the convertible top by
hand when closing it for the first time. If the con-
vertible top stops right before the closing phase
is completed, press against the front part of the
convertible top frame from the outside to help
the closing process along. Keep pressing the
button while doing so until the top starts mov-
ing on its own again.<

Indicator lamps

> The red LED in the button is lit while the
convertible top is in motion. It goes out as
soon as the opening or closing operation
has been completed.
> If the red LED in the button flashes after the
button has been released, then the opening
or closing operation has not yet been com-
pleted.
The movement can be continued in the
desired direction by pressing this button.
> If the yellow LED in the button comes on
when the button is pressed, the convertible
top compartment panel in the cargo bay has
been folded up. The convertible top cannot
be moved.
Interruption
The automatic sequence will be interrupted
immediately if you release the button that oper-
ates the top. The sequence can be continued in
the desired direction by pressing this button.
Do not close the side windows using the
power window buttons before the closing
procedure has been completed. Otherwise the
side windows may not close properly against
the rubber seal of the convertible
Convenience operation

Remote control

Refer to page 19.
28
Online Edition for Part no. 01 41 0 013 320 - © 02/07 BMW AG
Driver's door
Refer to page 20.
To close manually in the event of a
malfunction
1. Pull out the handle in the cargo bay as far as
it will go.
2. Turn the handle 90° until it engages.
3. Grip the convertible top by its frame and
guide it all the way to the windshield frame.
4. Pull out the cover panel that is in the center
of the front convertible top frame.
top.<
5. Insert the Allen wrench into the hex slot.
The Allen wrench is stored in a tool pouch,
refer to page 98.