Baumatic BR22.8A User Manual page 28

o Remove the pin from the lower freezer hinge and place it in the
hole that is in the hinge on the opposite side of the cabinet.
o Hang the freezer door on to the lower freezer hinge first and
then to the top freezer hinge.
o Re-fix the upper fridge hinge to the cabinet, on the opposite side
to its original position.
o Hang the fridge door onto the upper fridge hinge first and then
to the lower fridge hinge.
IMPORTANT: THE FRIDGE DOOR MUST BE SUPPORTED FROM
THE UNDERNEATH, UNTIL IT HAS BEEN HUNG ON BOTH OF
THE HINGES.
o Replace the top hinge cover on the fridge cabinet.
o Replace the blanking caps; they should be placed in the holes
that are in the cabinet on the opposite side from their original
position. There are also blanking caps that are on the top of each
door. These should also be swapped over to the other side of
each door.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a damp cloth and manipulate the seal until it does adhere
to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
28