Clearing A Clogged Grinder; Cleaning The Grounds Chute; Cleaning The Paddle Wheel - Baratza Virtuoso Operation Manual

If your grinder is not dispensing coffee normally, it could be clogged
with coffee powder. This can happen if the grounds bin or portafilter are
allowed to overfill and ground coffee gets backed up into the grounds
chute and grinding chamber. It can also happen with the build up of cof-
fee powder over time.
Photo # 1
Photo # 2
is broken or warn, go to www.baratza.com troubleshooting to see how to
purchase and replace the paddle wheel.

Clearing a Clogged Grinder

Cleaning the Grounds Chute

To clear the grinder remove any beans that remain
in the bean hopper, then remove the bean hop-
per. Also remove the ring burr and the grounds
bin. Check to see if the grounds chute is clogged
by looking at the exit of the grounds chute which
is located at the top of the recess that holds the
grounds bin (see photo # 1). If clogged, remove
the coffee grounds with a stiff piece of wire such
as a straightened jumbo paper clip and your clean-
ing brush.

Cleaning the Paddle Wheel

Looking at the grinder from the top you'll see the
cone burr in the center and a paddle wheel with
four fins that rotates at the base of the cone burr
(see photo # 2). During grinding these fins push
the ground coffee out of the grinding chamber.
Ground coffee can get tightly packed between the
fins. Use a straightened jumbo paper clip (or simi-
lar) to remove any coffee powder lodged between
the fins. Once all the coffee is removed, make
sure that all four fins are present and reach to the
wall of the grinding chamber. If the paddle wheel
9