Turning The Imager On And Off; Features And Controls - Fluke TiS User Manual

TiS
Users Manual
While the battery is charging, the battery icon appears as  while the
Imager is operating. With the Imager off,  appears in the display while
connected to the battery charger.
Keep the Imager attached to the charger until the battery condition icon
indicates a full charge. With the Imager off, the battery charge icon will have
four full bars. With the Imager on, turn the Imager off to view the battery
condition icon. Removing the Imager from the charger before a full charge is
indicated will deprive the battery of a full charge and thus shorten the run time.
New batteries are not fully charged. Two to ten normal
charging/discharging cycles may be required before the battery
charges to its maximum capacity.

Turning the Imager On and Off

To turn the Imager on or off, press the center softkey () for two seconds.

Features and Controls

Imager features and controls are shown and described in Table 2.
4
Note