Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Euromaid COND6KG
Summary of Contents for Euromaid COND6KG
- Page 1 COND6KG Dryer...
- Page 2 Read this manual prior to initial operation of the product! Dear Customer, We hope that your product, which has been manufactured in modern facilities and passed through a strict quality control procedure, will give you very good results. We advise you to read through this manual carefully before using your product and keep it for future reference.
-
Page 3: Important Safety Information
Important safety information This section includes safety information that will well as the items that are contaminated help protection from risks of personal injuries or spotted with such materials should not or materialistic damages. Failure to follow be dried in the product since they emit these instructions shall cause any warranty and flammable or explosive vapor. -
Page 4: Intended Use
water! There is the risk of electric shock! instruct them accordingly for use of the Always disconnect by unplugging from the product. mains before cleaning. Children’s safety • Never touch the plug with wet hands. • Electrical appliances are dangerous for Never unplug by pulling on the cable, the children. -
Page 5: Appropriate Installation Location
Installation Refer to the nearest Authorised Service Agent approximate weight of both machines may reach 180 kg when they are full. Therefore, for installation of your product. the floor must be capable of carrying the Preparation of location and electrical load on it! installation for the product is under Adjusting feet... -
Page 6: Disposing Of Packaging Material
Disposing of the old machine cables or multi-plugs. • The main fuse and switches must have a Dispose of your old machine in an contact distance of minimum 3 mm. environmentally friendly manner. Damaged power cable must only be Refer to your local dealer or solid waste replaced by a qualified electrician. -
Page 7: Initial Preparations For Drying
Initial preparations for drying Things to be done for energy saving: A B C • Make sure that you operate the product at its full capacity but pay attention to not exceeding it. • Spin your laundry at the highest speed possible when washing them. -
Page 8: Preparing Laundry For Drying
foam (latex foam), shower bonnets, water dryer 1-2 times during drying process to resistant textiles, materials with rubber separate bunched-up laundry. reinforcement and rubber foam pads Following weights are given as examples. should not be dried in the dryer. Approximate •... -
Page 9: Control Panel
Selecting a Program and Operating Your Machine Control panel Synthetics Ready to Ready to Wear Cottons Iron Extra Dry Timer 10 min Ready to Wear Programmes Start/ Clean Filter Drying 20 min Ready to Iron Pause On/Off Ready to Water Tank Full Iron 40 min Delicates... -
Page 10: Preparing The Machine
Preparing the machine creasing. Special programs 1. Plug in your machine. For special cases, there are also extra programs 2. Place the laundry in the machine. available: 3. Press the “On/Off” button. Additional programs may differ according to Pressing the “On/Off” button does not the model of your machine. -
Page 11: Childproof Lock
restart the machine, please drain the water in through canceling) the water tank. Press “Start/Pause/Cancel” button to start the programme after you have Adding/removing laundry in standby emptied the water tank. The warning LED goes mode off and the programme resumes operating. In order to add or take out laundry after the start-up of the programme;... -
Page 12: Ending The Programe Through Canceling
Ending the programe through canceling The programme which is selected first will keep on going even if the position of the programme selection button is changed. A new programme can be selected and started after “Programme cancel” is activated in order to change the drying programme. -
Page 13: Maintenance And Cleaning
Maintenance and cleaning Lint filter dampened with vinegar and dry them. Lint and fibres released from the laundry to Clean metal sensors 4 times a year. the air during the drying cycle are collected in the “Lint Filter”. Never use solvents, cleaning agents or similar substances when cleaning since these materials can cause fire and explosion! -
Page 14: For The Condenser (Products With A Condenser)
For the condenser (products with a condenser) Hot and humid air in the condenser is cooled with the cold air from the room. Thus, the humid air circulating in your dryer is condensed and then pumped into the tank. Clean the condenser after every 30 drying cycles or once a month. -
Page 15: Solution Suggestions For Problems
Solution suggestions for problems Drying process takes too much time • Meshes of the filter may be clogged. Wash with water. Laundry come out wet at the end of drying. • Meshes of the filter may be clogged. Wash with water. •...
Need help?
Do you have a question about the COND6KG and is the answer not in the manual?
Questions and answers