Table of Contents
Advertisement
THERMOSTAT QUICK REFERENCE
Before you begin using your thermostat, you should be familiar
with its features and with the display and the location and
operation of the thermostat buttons and switches (see fig. 5).
Your thermostat consists of two parts: the thermostat cover
and the base. To remove the cover, pull it straight out from the
base. To replace the cover, line up the cover with the base and
press until the cover snaps onto the base.
The Thermostat Buttons and Switches
1
Raises temperature setting.
2
Lowers temperature setting.
3
SYSTEM switch (COOL, OFF, HEAT).
FAN switch (ON, AUTO).
4
The Display
Indicates setpoint temperature. This is blank when system
5
switch is in the OFF position. Setpoint temperature is
displayed (flashing) if the thermostat is in lockout mode to
prevent the compressor from cycling too quickly.
"Save" indicates the Cool Savings feature is enabled in
6
the configuration menu. "Save" (flashing) indicates Cool
Savings feature is active.
Flame icon ( ) is displayed when the SYSTEM switch is
7
in the HEAT position. Flame icon ( ) is displayed flashing
when thermostat is calling for heat. Snowflake icon ( ) is
displayed (non-flashing) when the SYSTEM switch is in
the COOL position. Snowflake icon ( ) and is displayed
(flashing) if the thermostat is calling for cool.
8
Displays current temperature.
INSTALLER/CONFIGURATION MENU
The configuration menu allows you to set certain thermostat operating characteristics to your system or personal requirements.
To enter the menu: Set your thermostat to OFF and press the
item in the configuration menu. Press
Cool or Heat. If no keys are pressed within fifteen minutes, the thermostat will revert to normal operation.
Menu
Press
Reference
Key
Number
1
and
2
and
and
3
and
4
and
5
and
and
to change to the next menu item. To exit the menu, set the system switch to
Configuration Menu
Displayed
Press
(Factory
to select from
Default)
listed options
SS
HP
CS
On
(OFF)
CS
1, 2, 3, 4, 5, 6
(3)
CR Heat
FA, SL
(ME)
CR Cool
SL
(FA)
CL
On
(OFF)
4
9
"Service" indicates a diagnostic fault in the heating/cooling
system. It does not indicate a fault in the thermostat.
10
"Change Filter" is displayed when the system has run
for the programmed filter time period as a reminder to
change or clean your air filter.
11
" indicates power level of batteries. "Change
"
indicates batteries should be replaced.
Figure 5. Thermostat display, buttons, and switches
SYSTEM
3
11
10
9
and
buttons simultaneously. The display will show the first
or
Select Single Stage (SS) or
Heat Pump (HP, 1 compressor)
Select Cool Savings Feature On or OFF
If CS selected On, selects Cool Savings value
Select Adjustable Anticipation, cycle rate,
Heat Single Stage
Select Adjustable Anticipation, cycle rate,
Cool Single Stage
Select Compressor lockout OFF or On
2
4
5
6
8
7
Comments
"
Hide quick links:
Advertisement
Table of Contents
