Adjustment Of Display - Acer AL 2017 Quick Start Manual

Installation guide Note: Read the [Important] section carefully before starting the installation.
Quick installation Complete the following steps for quick installation (see the figure):
Assemble the seat of the display
Connection to PC

Adjustment of display

Key definition
1
2 Menu
3
4
5 Auto
6 Speaker
Take out the seat out of the box and place it on a flat
table.
Take your LCD display out of the carton and assemble
the display and seat along the rail. You will hear a
click sound when the display and seat are engaged
correctly.
Make sure that the power supply of your PC is turned
off and the power plug is removed.
Connect and fasten both ends of the signal cable to
your PC host and LCD display, respectively.
If your LCD display has built-in speakers, connect the
audio cable attached to the display from the sound
card output of your PC to the audio input on the back
of your LCD display.
Connect the attached power cable to your LCD
display.
Plug the power cable to the receptacle.
Use the cable tie to bind up the power cord and the
D-sub signal cable / DVI-D cable.
Turn on the power supplies of your PC and LCD
display.
Power source
OSD Menu
> Plus
< Minus
Automatic
adjustment
(For models with
speakers)
Power On/Off
Green indication: Power is on and normal.
Orange indication: Sleep status in the energy-saving mode.
Colorless indication: Power off.
Press this button to enter OSD. Press it again to exit OSD.
Press this button for selection or adjustment when OSD is
started.
Press this button and click < and > to adjust volume when OSD
is not started (for models with speakers only).
Press this button to exit the manual when OSD is started.
Press this button for the display to optimize the position, phase
and clock pulse automatically when OSD is not started.
2
Power cable
Audio cable
DVI signal cable
(optional)
D-Sub signal cable