Quick Install Instructions - Avaya SoundBrick 500 Installation And Operation Manual

QUICK INSTALL INSTRUCTIONS

For more detailed instructions, read the inside of the manual.
1. Consult message length table on page 8 if needed. Set option (DIP) switches:
--Message play, switch 1 (off = continuous play MOH, on = trigger play
enable)
--Bandwidth, switches 2-3 (see table 3, page 9)
Note: A switch is on when it is pointing towards the switch numbers and
off when it is pointing away from the switch numbers.
2. Connect the power supply and phone system as shown above. Connect optional
trigger cable, if applicable.
3. Turn the power switch on. Press the eject button on front of the SoundBrick to
open the motorized tape drawer. Insert the cassette into the tape drawer by
gently sliding it underneath the retaining clip, audio side facing front, then
momentarily push the drawer or press the eject button again to close the drawer.
4. A 10-second preview of the tape is played through the internal speaker. This
can only be heard if the speaker is on. The tape then rewinds and begins to load
into memory automatically. After tape load, message playback begins
automatically.
SoundBrick 500
12VDC power supply
(included)
1/8" mini-plug trigger cable (optional)
mono RCA cable (included)
Connect to trigger hardware
Connect to phone system's
MOH port
18
01/08/2001