Threading The Machine; Winding The Bobbin - Brother CS-6000i Instructions Manual

NCBC2000.book Page 11 Thursday, October 21, 2004 4:32 PM

THREADING THE MACHINE

Winding the bobbin

This section describes how to wind the thread onto the bobbin.
• For details on the fast bobbin winding, see page 13.
CAUTION
● Only use bobbins (part code: SA156, SFB: XA5539-151) that have been designed for this sewing
machine. Using other bobbins may cause damage to the machine.
● We designed the bobbin that comes with this machine. If you use bobbins from other models, the
machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the
same type (part code: SA156, SFB: XA5539-151).
a
Pull up the spool pin as far as possible, and
then put a spool of thread on this pin.
b Pass the thread around the pre-tension disk.
CAUTION
● If the spool of thread is not in the right place,
the thread may tangle on the spool pin.
c Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
a Pre-tension disk
b Bobbin winder shaft
c Bobbin
Actual size
11.5 mm
(7/16 inch)
This model
d
e
Other models
Put the bobbin onto the bobbin winder shaft
and slide the bobbin winder shaft to the right.
Turn the bobbin clockwise, by hand, until the
spring on the shaft slides into the groove of
the bobbin.
1 2
a Spring on the shaft
b Groove of the bobbin
Turn on the sewing machine.
1
11