Table of Contents
Advertisement
3. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when
using ribbon cables with pin 5 plug).
P4B266-C
P4B266-C Floppy Disk Drive Connector
4. Chassis open alarm lead (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you open the chassis, the
sensor triggers and sends a high-level signal to this lead to record a
chassis intrusion event.
If you do not wish to use the chassis intrusion lead, place a jumper cap
over the pins labeled "Chassis Signal" and "Ground" to close the
circuit.
P4B266-C
P4B266-C Chassis Alarm Lead
2-26
®
®
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
CHASSIS
GND
Chassis Signal
+5VSB_MB
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
