CX1252R 0.125A, 250V, Slow Blow 70-21001 3AG, 1/4 x 1 1/2” (6.35 x 32mm) May you enjoy many years of success and fun with your new CARVIN mixer! CX842 3A, 250V, Slow Blow 70-22030 3AG, 1/4 x 1 1/2” (6.35 x 32mm)
RISK OF ELECTRIC SHOCK QUALIFIED SERVICE PERSONNEL! mixer unplugged and the unit turned off, complete the following procedures: Ref Des Description CARVIN No. Capacitor Poly .033µF 100 Volt 10% 46-33312 1. CONNECTING AC POWER TO YOUR MIXER Capacitor Poly .001µF 100 Volt 10%...
SPEAKER CONNECTIONS 6. CHANNEL PAN CONTROL The PAN control adjusts where the channel is heard in the stereo field of the stereo main outputs. If it is turned Here are two possible speaker connections, two or four 8 ohm speakers with to the extreme left, then the channel will only be heard in one or one pair to each 1/4”...
Page 5
4. TAPE/EFFECTS RETURN LEVEL CONTROL The TAPE/ EFF RTN control is a stereo effects or tape return volume control. It can receive input from both the L/R TAPE RTN RCA jacks and the L/R 1/4” EFFECTS RETURN jacks. This volume controls the return level being fed back into the master L/R stereo mix.
Page 6
“Direct box” (both are available from Carvin or other electronics outlets). Verify that all the connec- tions are good and that all mics are connected properly. The next step is con- SELECTING AN EFFECTS PROGRAM (EFFECT) necting the speakers outputs.
Page 7
GREEN OR CONSEQUENTIAL DAMAGES. In the interest of creating new products and improving existing ones, Carvin is continually researching the latest state of the WARNING: If the ground is defeated, certain fault conditions in the unit or in the sys- art audio design methods, and modern packaging and production techniques.
CHANNEL FEATURES 1. LINE INPUT JACK The LINE input is a 1/4” phone jack designed for unbalanced line and instrument level inputs. Examples of these inputs would be instruments such as a guitar, a keyboard, an unbalanced mic, or a pre-amp output. The line input can be used at the same time the mic input is being used.
MASTER SECTION FEATURES L GRAPHIC EQ –12 R GRAPHIC EQ –12 L/R MAIN STEREO DSP POWER PHANTOM BYPASS DELAYS 2 - 30 127 EFFECTS REVERB 31 - 90 CHORUS 91 - 110 FLANGE 111 - 128 MONITOR DSP EFF RTN TAPE SEND TAPE...
Page 11
lem has been corrected start again with turning up the low level signal and use The RCA jacks are Ideal for using a cassette deck to record a mix with using the this low level signal to check if all the speakers are working. Now the main sys- TAPE SEND jacks and playing it back through the TAPE RETURN jacks with out tem is ready for the sound check.
REVERB Small Room 3.9s decay 113 FLANGE Fast & 6mS depth cable or more commonly referred to as a “Snake” (available from CARVIN). REVERB Medium Room 0.5s decay 114 FLANGE Slow & 13mS depth Each of the microphones and instruments are plugged into the snake box at the REVERB Medium Room 0.7s decay...
Need help?
Do you have a question about the CX1252 and is the answer not in the manual?
Questions and answers