Troubleshooting Guide; Declaration Of Conformity - Binatone Terrain 550 User Manual

10.Troubleshooting Guide

Symptom
No power.
Reception
is weak.
Cannot change
CTCSS sub-
channels.
Range is limited.
Sound distortion
problems.
No
communication
This equipment is intended for use in:
Austria
Belgium
Bulgaria
Croatia
Cyprus
Czech
Denmark
Estonia
Countries of use

Declaration of Conformity

The Binatone Terrain 550
And conforms to the following relevant standards:
ETSI EN 300 296-2 V1.1.1
ETSI EN 301 489-5 V1.3.1
ETSI EN 301 489-1 V1.4.1
EN 60065: 2002
Binatone Telecom plc operates a policy of continuous product
improvement, and so reserves the right to make changes to the product
and functions without prior notice.
Solution
Check if the batteries are installed properly.
The battery may be weak.
Replace the old batteries with new one.
Press the UP button to increase the receiver volume level.
The receiving signal may be weak and/or out of range.
If this happens, press the
time to activate the Monitor function.
Key lock mode must be deactivated if the Key lock icon (
displayed on the LCD Screen.
To change CTCSS sub-channels, press the
CTCSS sub-channel number flashes on the LCD Screen.
Press the UP or DOWN
Batteries may be weak.
Batteries may be weak.
Replace with new batteries
See the "Effective Range" diagram.
The maximum range will vary depending on terrain and environment.
Open fields provide the maximum range, while steel/concrete
structures, heavy foliage, and use in buildings and in vehicles may
limit the range significantly.
Wearing the radio close to the body, such as in a pocket or on a
belt, will decrease range; change the location of the radio.
If you are transmitting, speak in a normal tone of voice, 5 cm
away from the MIC (microphone.).
If you are receiving, lower the volume to a comfortable level.
Radios too close. Radios must be at least 2 meters apart; increase
your distance.
Radios too far apart. Obstacles interfere with transmission. Talk
range is up to 8 Kms. in a clear unobstructed conditions.
Check the Channel and the CTCSS code setting. Both the
Transmitting and Receiving PMR units should have tuned to the
same Channel and CTCSS code (if applicable).
Finland Latvia
France Liechtenstein
Germany Luxemburg
Greece The Netherlands
Hungary Norway
Iceland Poland
Ireland Portugal
Italy Slovenia
complies with the essential requirements
MENU and DOWN buttons at the same
MENU button twice, the
button to change the CTCSS sub-channel.
if the charge level indicator gets low.
Spain
Sweden
Switzerland
Turkey
UK
Romania
Slovakia
Waste electrical products must not be
disposed of with household waste.
This equipment should be taken to
your local recycling centre for safe
treatment.
UK (BTP) Ver 3 Jan.08
) is