LG N4B2N User Manual page 21

2. LG Network Storage Installation
4 Insert the "LG NETWORK STORAGE Installer" disc and push the "DISC OPEN" button to
close the tray. The messages "Checking LG Network Storage " and " Loading kernel "
indicate that the NAS is preparing to organize system files.
5
After 1 minute, the following two messages appear. Click on 'SET' and select 'S:YES'
'S' indicates the 'SET' button and 'M' indicates the 'MODE' button.
If manual selection of the RAID level and volume configuration are desired, press the
MODE button to select 'M: Custom Setup' When 'Custom ? /M:No S:yes' is shown, select Y:
Yes(User to configure volume & RAID. The system file will be installed and LG NETWORK
STORAGE will reboot. The volme can then be configured using web menus. For detailed
<Volume>
contents see
The RAID disperses the data to multiple hard disks to guard from data loss due to
physical damage. The default volume configuration of the LG NETWORK STORAGE
depends on the number of the installed HDDs.
The table below shows the list of the default RAID level configuration.
Default RAID Level
Hard disk numbers
DEFAULT RAID Level
For detailed contents see
1
ONLY 1 DISK
(No RAID)
<Appendix A Volume and RAID
1
2
RAID 1 (mirroring)
Configuration>.
3 or 4
RAID 5 (parity)