Viking FDWB301R Installation Instructions

INSTALLATION
INSTRUCTIONS
TOP-30, TOP-36, TOP-42, TOP-48
TOP PANEL KIT
For Use with Built-In Refrigerator/Freezers and Full Height Wine Cellars
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings or plates from the product. This may void the warranty.
•Please refer to installation instructions included with the product for site preparations and considerations.
•The installer should leave instructions with the consumer who should retain for local inspector's use and for future
reference.
CAUTION: Always wear gloves when handling top and side panels. Some edges may be sharp enough to cause injury
during handling.
The unit must be fastened to a wall located at the rear of the product. Failure to properly fasten the product
to the wall can result in death or serious injury. See installation instructions included with the product for
proper securing methods.
Parts Included:
(1) Stainless steel top panel
(6) Stainless steel wafer head screws (Part number - M0210417)
(2) Wood screws (min 1.5" long) (Part number - PD020016)
To install top panel with two side panels:
1. The top panel will be fastened to an adjacent wall that is to be located behind the unit. This is to provide an anti-
tip device in lieu of the product being placed into a fixed enclosure. The unit should be anchored to wall studs
(minimum of two). Before positioning the unit in place, locate the wall studs.
2. Locate the unit in front of the area in which it is to be installed (approximately two feet directly in front of the final
position).
3. Place the top panel on top of the unit.
4. Position the side panels behind the cabinet side trim such that the top flanges of the side panels overlap the top
panel.
5. Insure that side panels are fully located behind the side trim and that the rear flanges of the panels are making
contact with the rear of the unit. (figure 1)
6. Using the 6 stainless steel wafer head screws, attach the side panels to the top panel by screwing through the side
panels into the top panel on each side (figure 2)
Figure 1
WARNING!
Side panel
goes behind
trim
VIKING RANGE CORPORATION
Greenwood, Mississippi 38930 USA
Required Tools:
Electric drill
9/64" (.36 cm) diameter drill bit
Figure 2
111 Front Street
(662)455-1200