Table of Contents
Advertisement
PREPARATION
ATTACHING THE IR BLASTER
7KH ,5 EODVWHU DOORZV WKH /* 79 WR FRQWURO H[WHUQDO HTXLSPHQW OLNH D FDEOH ER[
1
Connect the provided IR Blaster cable to the
IR Blaster terminal on the Wireless Media Box.
L R
A
B
VIDEO
L MONO)
AUDIO
R
VIDEO
3
OPT CAL D GITAL
2V
SERV CE ONLY
AUD O OUT
NOTE
When you attach the IR Blaster sensor near the remote control sensor of the external device, the
signal can be detected more efficiently.
OPTIMAL LOCATION OF EXTERNAL DEVICE WITH IR
BLASTER INSTALLED
NOTE
For some external devices, the IR Blaster may not operate depending on the performance of the
IR receiver.
The operation may be delayed due to the sensitivity of the wireless signal.
10
L R
A
COMPONENT / AV N 1
B
COMPONENT / AV N 2
(MONO)
AUDIO
R
AUDIO IN
2
1
/ DVI IN
RGB IN(PC)
RGB/DVI
SE VI E ONLY
2
After removing the protection paper from the
IR Blaster cable, adhere it to the external
equipment as shown.
IR Receiver
Install the external device with the IR Blaster
installed at a location it is not affected by the sig-
nal from the remote controller to the TV.
When the external device with the IR Blaster
installed receives the signal from the remote con-
troller simultaneously with the TV, it may not
operate.
Advertisement
Table of Contents
