Printed Wiring Boards And Schematic Diagrams - PlayStation SCPH-7501 - Game Console Service Manual

Reproduction Prohibited
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
Note on Printed Wiring Boards :
• Through hole is omitted.
• : Pattern on the side which is seen.
Note on Schematic Diagram :
• Use caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
• All capacitors are in F unless otherwise noted. pF :
or less are not indicated except for
• All resistors are in
otherwise specified.
• Chip resistors are 1/8 W or 1/10 W unless otherwise noted.
k : 1000 , M : 1000 k .
Note :
The components
identified by mark
dotted line with mark
are critical for safety.
Replace only with part
number specified.

PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

F 50 WV
electrolytics and tantalums.
and 1/4 W (Chip resisters : 1/10w) unless
Note :
Les composants identifies par
or une marque sont critiques
! !
pour la securite.
!
Ne les remplacer que par une
piece portant le nubero specifie.
SECTION 6
— 7 —
SCPH-9000
SERIES