Table of Contents
Advertisement
Volume Control
The speaker volume can be adjusted when the unit is announcing
an incoming call, playing back a number or VIP Message, or when
the unit is in standby mode.
1. When the unit is announcing an incoming call, or playing back
a number or VIP Message, press VOLUME to adjust the vol-
ume. The volume level cycles between "OFF LOW HIGH" as
you continue pressing VOLUME.
2. Stop pressing VOLUME when you get to the desired volume
level. After the selection has been made, the unit will return to
standby mode after a few seconds.
Receiving Call Waiting Caller ID Information
If you subscribe to Call Waiting Caller ID (a service which may be
available in your area), your unit will display and announce the
identity of an incoming Call Waiting call while you are on the line
with another caller. Immediately following the Call Waiting Beep,
your phone will be momentarily muted during the transmission of
the Call Waiting information, usually less than one second. The
Call Waiting Caller ID information will be displayed and the tele-
phone number or Voice VIP message will be announced over the
speaker. The New Caller's information is stored in the Call Log for
later review.
Troubleshooting
No Caller Identification information is shown on the display
when I receive a call.
6090 eng
page 20
19
Thursday, March 02, 2000 22:50
Composite
Advertisement
Table of Contents
