Maintenance And Care; Dirt Container - Bissell PowerForce Helix Turbo Bagless User Manual

M
aintenance and Care
To maximize performance and extend life
of your vacuum, it is very important to
perform the following maintenance steps.
Empty Easy Empty™

Dirt Container

Empty when dirt reaches the "Full" line on
the container
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
Slide Lock 'n Seal lever to "Unlock" position.
3.
Grasp dirt cup portion handle and pull
straight out to remove from vacuum and
empty.
4.
Place dirt container back in the vacuum and
slide lever to lock position.
NOTE: The dirt container may be
washed in warm water with mild
detergent. Make sure it is completely
dry before replacing.
Cleaning Inner & Outer
Circular Filter
1.
Turn power OFF. Unplug vacuum cord from
electrical outlet
2.
Remove dirt container. Grasp the filter
located at the bottom of the dirt container,
lift and pull straight out. DO NOT PULL
CIRCULAR FOAM FILTER OUT OF THE FILTER
CUP WHILE IT IS STILL IN THE VACUUM.
3.
Grasp the plastic tab on the top of the circular
foam filters. Twist to unlock and pull out.
4.
Separate the outer foam filter and inner
pleated circular filter. Wash each individually
by hand in warm water. Mild detergent may
be used if desired. Rinse well, let filters
completely air dry before replacing in filter
cup.
5.
Wash filter cup in warm water with mild
detergent. Completely air dry before
reassembling with filters. DO NOT PUT IN
DISHWASHER.
6.
The upper tank and louvers can be wiped
clean with a damp cloth. Reach underneath
the upper tank and turn the rim of the
louvers to the left to unlock. Pull straight
down and remove. Make sure all parts are
completely dry before replacing.
7.
To replace louvers, position top of louvers
inside clear center cavity and turn toward
the right to lock tabs into place.
2 3
4
6
9