AEG SANTO 3288-6 KG Operating Instructions Manual page 15

Symptom
The food is too warm.
Interior lighting does not work.
Heavy build up of frost, possibly
also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing the
temperature setting.
Water on the floor or on stora-
ge shelves.
If after all these checks your appliance does not operate correctly, contact
your local AEG Service Force Centre.
Please note that it will be necessary to provide proof of purchase for any in-
guarantee service calls.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechanical or
electrical breakdown.
Possible Cause
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight (possi-
bly after reversing the door).
Appliance is not level.
The appliance is touching the
wall or other objects.
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature regulator
to a colder setting.
Please look in the "Installation
location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the non sealing
sections of the door seal with a
hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
15