Safety: Lamp Disposal - Dell W2600 - 26" LCD TV Product Information Manual

Product information guide
Hide thumbs Also See for W2600 - 26" LCD TV:
Table of Contents

Advertisement

Available languages

Available languages

Wall or Ceiling Mounting — The TV should be mounted to a wall or ceiling only as recommended by the
manufacturer.
Power Lines -— An outdoor antenna should be located away from power lines.
Outdoor Antenna Grounding — If an outside antenna is connected to the receiver, be sure the antenna system is
grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the
National Electric Code. ANSI/NFPA No.70-1984, provides information with respect to proper grounding of the
mats and supporting structure grounding of the lead-in wire to and antenna-discharge unit, size of grounding
connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the
grounding electrode.
Example of Antenna Grounding as per National Electrical Code (NEC)
Electric Service Equipment
See the limited warranty section for service of your TV. Servicing is required when the TV has been damaged in
any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into TV the
TV has been exposed to rain or moisture, does not operate normally, or has been dropped.
Keep these instruction.
Heed all warning.
Clean only with a dry cloth.
NOTE:
This note is for cabel TV installers, Article 820-40 of the NEC that provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the grounding system fo the building, as close to the point of
cable entry as practical.

SAFETY: Lamp Disposal

Hg
THE LAMP(S) INSIDE THIS PRODUCT CONTAIN(S) MERCURY AND MUST BE
RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE, OR FEDERAL LAWS.
FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT
WWW.EIAE.ORG.
18
Product Information Guide
Ground Clamp
Ground Clamp
Power service grounding electrode system
(NEC Art 250 , Part H )
Antenna Lead in Wire
Antenna Discharge Unit
(NEC section 810-20)
Grounding Conductors
(NEC section 810-21)

Advertisement

Table of Contents
loading

This manual is also suitable for:

W2600

Table of Contents