Hard-wired ac powered moments lavatory proximity faucet (9 pages)
Summary of Contents for Selectronic 6059.193
Page 1
M 9 6 5 2 7 1 NOTE TO INSTALLER: Please give this manual to the customer after installation. To learn more about American Standard Faucets visit our website at: www.us.amstd.com or U.S. customer's e-mail us at: faucetsupport@amstd.com For Parts, Service, Warranty or other Assistance,...
Page 2
M 9 6 5 2 7 1 NOTE TO INSTALLER: Please give this manual to the customer after installation. To learn more about American Standard Faucets visit our website at: www.us.amstd.com or U.S. customer's e-mail us at: faucetsupport@amstd.com For Parts, Service, Warranty or other Assistance,...
Roughing-in Dimensions FINISHED WALL GENERAL DESCRIPTION: (243mm) (127mm) 9-9/16" Electronic faucet with proximity operation. Vandal 5" resistant solid brass construction single post mounting. Operates on AC permanent power. In-line strainer for solenoid is integral. Single inlet (53mm) (133mm) 3/8 compression, built-in checks, and flexible 2-1/8"...
Page 4
21" NOTE. The illustration shows the ICU FAUCET mounted (533mm) on the American Standard ICU Sink. Faucet can be installed on almost any sink or countertop. For Faucet installation on the American Standard ICU Sink, see instruction sheet No. 7301793-100 (ICU Sink System) 14"...
ELECTRICAL INSTALLATION Fig. 1 ELECTRICAL CONNECTIONS; Fig. 1 Before opening ENCLOSURE CAUTION disconnect AC power supply. 1. Remove ENCLOSURE COVER (1). Fig. 1. 2. Feed the WIRE CONNECTORS (2) through the top of ENCLOSURE (5). Fig. 1a. 3. Remove GROMMET (4) from ENCLOSURE (5). Fig. 1. Fig.
Page 6
Fig. 2 Unit #1 Unit #2 Unit #3 TWO PIECE TWO PIECE GROMMET GROMMET 4" FOR AC-VERSION Fig. 3a (MULTI HOOK-UP); Fig. 2, 3 TWO PIECE TWO PIECE 1. See AC Version Electrical Hook-up for first unit of the GROMMET GROMMET Multi hook-up.
TEST INSTALLED FAUCET Fig 1 TO ENSURE A LAMINAR WATER FLOW the air must be slowly purged from the spout. To do so, cover the SENSOR (1) while slowly opening the water supply valves. When the water flows as a solid, smooth, steady stream, uncover the SENSOR (1) and fully open the water supply valve.
Page 8
HOW TO CLEAN AND REMOVE Fig.4 THE FLOW RESTRICTOR; Fig. 4 REMOVE SET SCREW (1) 1. Remove SET SCREW (1) with FLAT BLADE SCREWDRIVER (2). Pull off SPOUT (3) from faucet base. Fig. 4 & 4a. 2. Remove HOUSING (4) and remove FLOW RESTRICTOR (5).
Page 9
FAQ'S Q: How will I know if battery needs to be replaced? Q: Why does the faucet operate the opposite of A: Valve does not open and sensor blinks 2 times expected-Turns On when not in sensor range, but turns interrupted by pause for up to 7 days.
Need help?
Do you have a question about the 6059.193 and is the answer not in the manual?
Questions and answers