Door Reversal - Electrolux ER 7628 B Instruction Book

Door reversal directions
1. Disconnect from the electricity supply.
2. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
inches) of packing;
3. Remove the ventilation grill (D).
4. Unscrew the bottom hinge (E).
5. Remove the freezer door by releasing it from the
middle hinge (H).
6. Unscrew the middle hinge.
7. Remove the fridge door by releasing it from the
top hinge pin (G).
8. Remove the pin then mount these on the side,
after having removed the small plugs which
should then be fitted on the opposite side.
9. Refit the fridge door and replace the middle hinge
to the left hand side.
9. Replace the door and bottom hinge (E) on the
opposite side.
10.Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side. Re-assemble
the ventilation grill (D).
11. Unscrew the handles. Refit them on the opposite
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs
contained in the documentation pack.
The doors can be aligned by adjusting the middle
hinge.
The middle hinge can be adjusted horizontally, after
having slackened the two screws with a screwdriver.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier on a low setting.
20
E
F
D
F
H
PR228
Printed on recycled paper
F
F
G