Advertisement
ELECTRICAL OUTLET
Electrical outlet location
Figure 7
The electrical requirements are a 120 volt 60 Hz, AC only,
15 amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded. Should you only have a 2-prong outlet, have a qualified
electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or service person.
GROUNDING INSTRUCTIONS
This appliance must be grounded. The Microwave Drawer is
equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded in accordance with the National
Electrical Code and local codes
and ordinances. In the event of
an electrical shor t circuit,
grounding reduces r isk of
electric shock by providing an
escape wire for the electric
current.
– Improper use
of the grounding plug can result
in a risk of electric shock. Do
not use an extension cord.
TINSEB 461MRR0
5"
4"
Permanent and Correct Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Ground receptacle box
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-2135
1-800-BE-SHARP (237-4277)
DRAWER INSTALLATION
(6")
Anti-Tip
block
Figure 8A
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply cord
into the electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between
the oven and the wall.
3. Slide the drawer all the way until the
mounting flange is flush with the face of the cabinet. See
Figure 8A.
4. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a 1/16" bit. See Figure 8A.
5. Secure the drawer with the 4 screws supplied. See Figure 8B.
MODEL AND SERIAL NUMBER LOCATION
For models KB-6015K and KB-6002L
The name plate, including model and serial number, is located
on the faceplate behind the Microwave Drawer front.
Temporary Use
Ground receptacle box
For model KB-6014L
Grounding adapter
The name plate includes model and serial number. Open the
Microwave Drawer fully. The label is slightly beyond the back
wall of the microwave cavity facing up from the flat surface.
Screw
Tab for grounding screw
CARE, CLEANING AND MAINTENANCE
Refer to the Operation Manual for cleaning instructions.
BEFORE YOU CALL FOR SERVICE
Read the BEFORE YOU CALL and operating instruction sections
in your Operation Manual. It may save you time and expense.
The list includes common occurrences that are not the result of
defective workmanship or materials in this range.
Refer to the warranty in your Operation Manual for Sharp's
toll-free service number and address. Please call or write if you
have inquiries about your microwave product and/or need to
order parts.
4
Mounting
flange
Parts supplied
4 Screws
Figure 8B
PRINTED IN USA
Advertisement
