Check The Printer; Connect The Printer To Your Computer; Connecting To A Pc - Epson Stylus Photo - Ink Jet Printer Quick Setup Manual

Note:
The printer is assigned to
parallel port LPT1; if you
want to use a different
port, see your Windows
documentation for
instructions.

Check the Printer

1. Turn off the printer.
2. Hold down the
power button. Hold down the buttons until the
light starts to flash. Then release the buttons.
A page prints out showing the ROM version and a nozzle
check pattern.
3. When it's finished, turn off the printer. If you have any
problems with the test, see Chapter 6 in your User's Guide
for more information.

Connect the Printer to Your Computer

You can connect your EPSON Stylus
compatible PC or an Apple
twisted-pair parallel cable to connect to a PC or an Apple
System Peripheral-8 cable to connect to a Macintosh. For a
complete list of system requirements, see the Introduction of
your printer User's Guide.

Connecting to a PC

1. Turn off the printer and your computer.
2. Connect the cable to the printer's parallel interface; then
squeeze the wire clips together until they lock in place. (If
your cable has a ground wire, connect it now.)
3. Connect the other end of the cable to your computer's
parallel port and secure it as necessary.
load/eject button and press the
™
Photo to either an IBM
® ®
Macintosh . You'll need a shielded,
power
®
ground
wire