AEG 2170-4 Operating Instructions Manual page 25

The temperature in the freezer is too high.
The compressor runs continuously
Excessive build up of frost.
Noise
The compressor does not start immedia-
tely after changing the temperature set-
ting.
If after the above checks there is still a fault, call your local AEG Service
Force Centre.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechani-
cal or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service
calls.
818 14 33-00/7
Sympton
Something not Working
Solution
Check the ambient temperature is within
the appliances operating limits
Check the temperature regulator is turned
to the correct setting relative to ambient
conditions.
Adjust the temperature regulator to give
correct temperature control.
Check that the door is closed.
Large quantities of food have recently
been placed in the cabinet and/or door is
frequently opened.
Check that air ventilation is not
obstructed.
If the door seal is not airtight (probably
after changing over the door hinges)
apply warm air to the non sealing area
using a hair dryer set to a gentle heat. (do
not use a fan heater for this purpose).
This will make the rubber more supple
and allow it to revert to its original shape.
Refer to Normal Operating Sounds
This is normal, the compressor starts after
a period of time.
25