Asus P5GC User Manual page 47

2.. ICH7R.Primary.IDE.connector.(40-1.pin.PRI_IDE)
This connector is for an Ultra DMA 100/66/33 signal cable. The Ultra
DMA 100/66/33 signal cable has three connectors: a blue connector for the
primary IDE connector on the motherboard, a black connector for an Ultra
DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray
connector for an Ultra DMA 100/66/33 IDE master device (hard disk drive).
If you install two hard disk drives, you must configure the second drive
as a slave device by setting its jumper accordingly. Refer to the hard disk
documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
IDE.Connector
P5GC.
3.. Serial.ATA.connectors.(7-pin.SATA1.[red],.SATA2.[red],.SATA3.[black],.
SATA4.[black])
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
P5GC.SATA.Connectors
ASUS P5GC
SATA1
SATA2
SATA3
SATA4
2-25