Asus P4T-CM User Manual page 32

3. HARDWARE SETUP
17) Standard and Consumer Infrared (SIR) Module Connector (5-pin IR)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard's SIR connector according
to the pin definitions.
P4T-CM
P4T-CM Infrared Module Connector
18) Front Panel Connectors (24-1 pin AFPANEL)
This connector allows you to setup an optional ASUS ipanel, an easy to access
operational console mounted in a standard front drive bay. The iPanel offers
front I/O ports, status LEDs and space reserved for a hard disk drive. (If you are
not using an ASUS iPanel, you can connect an optional wireless transmitting
and receiving infrared module to the SIR connector or an optional consumer
infrared connector set to the CIR and SIR connectors for both wireless transmit-
ting and remote control functions through one external infrared module.)
P4T-CM
P4T-CM Front Panel Connectors
32
®
1
®
SIR
CIR
ASUS P4T-CM User's Manual
Front View
IR
IRTX
GND
AFPANEL
IR_CON
Back View
+5V
(NC)
IRRX