AEG LAVAMAT 4520 User Information page 28

User information
Symptom
The washing cycle is much
too long :
**
The «End»* light
***
times :
The «End»* light ** flashes 2
times***:
The «End»* light ** flashes 1
time***:
The «End»* light** flashes
10 times ***
* Depending on the model.
** Eliminate the causes of the failure if you find them, and then press on the
«Start/Pause» pusbutton to restart the interrupted program.
*** Depending on the model, some acoustic signals may be activated.
28
Cause
• the water inlet is blocked,
• there was a power supply failure or the
water was cut off,
• the motor temperature safety device
tripped,
• the water inlet temperature is lower
than normal,
• the foam detection safety system trip-
ped (too much detergent) and the
washing machine evacuated the foam,
• the anti-unbalance mass safety device
tripped, an additional phase was
added to distribute the washing in the
drum better.
flashes 4 • the cover is not correctly closed.
• the drain filter is blocked,
• the drain pipe is blocked or kinked,
• the drain pipe is too high (see «instal-
lation»),
• the drain pump is blocked,
• the installation siphon is blocked.
• the water tap is closed,
• the water network has been cut off.
• the flaps of the drum door are opened.