Asus M2N-VM DVI User Manual page 42

5. CPU and Chassis Fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN)
The fan connectors support cooling fans of 350mA~740mA (8.88W max.) or
a total of 1A~2.22A (26.64W max.) at +12V. Connect the fan cables to the fan
connectors on the motherboard, ensuring that the black wire of each cable
matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! DO NOT place jumper caps on the fan connectors.
Only CPU Fan supports Q-Fan.
M2N-CM DVI FAN Connectors
6. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port(s). Connect the S/PDIF module cable to this connector, then install the
module to a slot opening at the back of the system chassis.
M2N-CM DVI Digital Audio Connector
The S/PDIF module is purchased separately.
1-30
R
M2N-CM DVI
R
M2N-CM DVI
CPU_FAN CHA_FAN
SPDIF_OUT
Chapter 1: Product introduction