Gigabyte G1.Sniper M3 User Manual page 11

Storage Interface Chipset:
Š
- 2 x SATA 6Gb/s connectors (SATA3 0/1) supporting up to 2 SATA 6Gb/s
devices
- 3 x SATA 3Gb/s connectors (SATA2 2~4) supporting up to 3 SATA 3Gb/s
devices
- 1 x eSATA 3Gb/s connector on the back panel supporting up to 1 SATA 3Gb/s
device
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the
USB Chipset:
Š
- Up to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through
the internal USB header)
- Up to 10 USB 2.0/1.1 ports (4 ports on the back panel, 6 ports available
through the internal USB headers)
Internal 1 x 24-pin ATX main power connector
Š
Connectors 1 x 4-pin ATX 12V power connector
Š
2 x SATA 6Gb/s connectors
Š
3 x SATA 3Gb/s connectors
Š
1 x CPU fan header
Š
3 x System fan headers
Š
1 x front panel header
Š
1 x front panel audio header
Š
1 x USB 3.0/2.0 header
Š
3 x USB 2.0/1.1 headers
Š
1 x Clear CMOS jumper
Š
1 x Trusted Platform Module (TPM) header
Š
Back Panel 1 x PS/2 keyboard/mouse port
Š
Connectors 1 x D-Sub port
Š
1 x DVI-D port
Š
1 x HDMI port
Š
1 x DisplayPort
Š
1 x eSATA 3Gb/s connector
Š
2 x USB 3.0/2.0 ports
Š
4 x USB 2.0/1.1 ports
Š
1 x RJ-45 port
Š
1 x optical S/PDIF Out connector
Š
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In/Mic
Š
In, Line Out, Headphone)
system performance of the RAID set may vary depending on the devices being
connected.
- 11 - Hardware Installation