Asus F2A55-M LK2 Series User Manual page 36

3. Serial ATA 3.0 Gb/s connectors (7-pin SATA3G 1~4)
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can
create a RAID 0, RAID 1, or RAID 10 configuration through the onboard controller.
F2A55-M LK2 PLUS
F2A55-M LK2 PLUS SATA 3.0Gb/s connectors
•
•
•
1-24
SATA3G_3
These connectors are set to AHCI mode by default. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows XP SP3 or later version.
®
When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
SATA3G_1
SATA3G_2
SATA3G_4
XP Service Pack 3 or later version before using Serial
®
Chapter 1: Product introduction