Asus A7S333 User Manual page 46

13) Power Supply Connectors (20-pin block ATXPWR)
This connector supports an ATX 12V power supply. The plug from the power
supply fits in only one orientation. Push down firmly ensuring that the pins
are aligned.
IMPORTANT!
recommended wattage: 230W) can supply at least 10mA on the +5-volt
standby lead (+5VSB). The system may become unstable and may
experience difficulty powering up if the power supply is inadequate. For
Wake-On-LAN support, the ATX power supply must supply at least 720mA
+5VSB.
®
A7S333
A7S333 ATX Power Connectors
14) SMBus Connector (6-1 pin SMB)
This connector supports SMBus (System Management Bus) devices. SMBus
devices communicate by means of the SMBus with an SMBus host and/or
other SMBus devices. SMBus is a multi-device bus that permits multiple
chips to connect to the same bus and enable each one to act as a master by
initiating data transfer.
®
A7S333
A7S333 SMBus Connector
34
Make sure that the ATX 12V power supply (minimum
ATXPWR
+12.0VDC
+5VSB
PWR_OK
GND
+5.0VDC
GND
+5.0VDC
GND
+3.3VDC
+3.3VDC
SMB_CON
1
Chapter 2: Hardware information
+5.0VDC
+5.0VDC
-5.0VDC
GND
GND
GND
PS_ON#
GND
-12.0VDC
+3.3VDC