ActiveForever.com CL 100-C Owner's Manual page 5

pipe, or conduit within 5 feet (1.5m) of the unit as needed to
comply with local requirements.
8. This appliance is provided with a ground-fault circuit interrupter
(located near the end of the power supply and with the unit
operating, push the test button. The unit should stop operating
and the reset button should pop out slightly. Push the reset button.
The unit should now operate normally. If the interrupter fails to
operate in this manner, there is a ground current flowing, indicating
the possibility of an electrical shock. Disconnect the plug from the
receptacle until the fault has been identified and corrected.
9. DANGER - RISK OF ELECTRICAL SHOCK. Install at least 5
feet from all metal surfaces. A spa may be installed within 5 feet of
metal surfaces if each metal surface is permanently connected by a
minimum of #8 (SWG 8.4 mm) solid copper conductor attached
to the wire connector in the Power Pack which is provided for this
purpose.
10. DANGER - Risk of Electrical Shock. Do not permit any electrical
appliance, such as a light, telephone, radio, or television, within 5
feet of spa or hot tub.
11. To reduce risk of injury:
A. The water in a spa or hot tub should never exceed 40°C
(104°F).Water temperatures between 38°C (100°F) and 40°C
(104°F) are considered safe for a healty adult. Lower water
temperatures are recommended for extended use (exceeding
10-15 minutes) and for young children.
B. Since excessive water temperatures have a high potential for
causing fetal damage during the early months on pregnancy,
pregnant or possible pregnant women should limit spa or hot
water temperatures to 39°C (100°F).
C. CAUTION: Before entering a spa or hot tub, the user should
measure the water temperature with an accurate thermometer
since the tolerance of water temperature-regulating devices
may vary as much as +/-3°C (5°F).
5